88-91 Civic/CRX Si Complete Intake manifold w/Throttlebody and Injectors
88-91 Civic/CRX Si Complete Distributor(TD-02U)
88-91 Civic/CRX Si Complete Engine Wiring Harness
88-91 Civic/CRX Si Injector Resistor Box
88-91 Civic/CRX Si PM6 ECU
88-91 Civic/CRX Si Throttle Cable
აი ეს ნაწილები მჭირდება......გავიგე მარტო 1 და ბოლოს წინა რა არის და მითხარით რა დანარჩენი რა არის?
* * *
What you need:
- the whole MPFI intake manifold from a D16A6/D16Z6/D15B7 with all the sensors/injectors and stuff ( I'll get into more detail on what you can skip or take from your DPFI unit later)
- a new intake manifold gasket You can go without it, but try not to....
- MPFI ECU either a PM6, PM7, or a PR4
- Si throttle cable You can go without that for now (as I did), but I strongly recommend you find one.
- MPFI distributor I cannot stress more on how much you need that. Especially if you have a 90-91 PM5 in your car. More on that - later.
- MPFI injector resistor box Although you can build one yourself as described below, these are cheap and it's not worth building.
- MPFI engine wiring harness This is extremely useful because you get all the connectors you need and maybe even the resistor box I mentioned above.
ან ესენი
* * *
intake manifold gasket?
Si throttle cable ?
MPFI distributor?
MPFI injector resistor box ?
MPFI engine wiring harness ?
ესენი რა არის?
* * *
Parts Required:
1. A complete intake manifold from an MPFI Engine. I recommend the D16Z6, but the D16A6, D16Y8, and D15B7 can also be used.
2. MPFI ECU. You will need a pm6, pr4, or pg7 (note: will run rich with pr4 and pg7). Make sure you replace the OBD-1 injectors with OBD-0 injectors if using a D16Z6, D16Y8, or D15B7 intake manifold.
3. MPFI Distributor TD-02. The stock DPFI TD-01 distributor will not work.
4. Resistor Box: This can be pulled from a Civic/CRX Si
5. Four MPFI injector plugs, 7 pin Si distributor plug, resistor box plug.
6. New intake manifold gasket
7. Si throttle cable. (Not absolutely necessary, but it is much better over the long DPFI cable)
I highly recommend soldering and heatshrink wrapping ALL connections
აქაც იგივეს წერს
▬▬HONDA CLUB GEORGIA >>>, Part XXVII▬, ------ 無限 Mugen Power-----
